1 Topic by Abolfazl

  • Abolfazl
  • Member
  • Offline
  • Registered: 2013-09-29
  • Posts: 14

Topic: WTB: Panelolu2 for Solidoodle3

I am looking to buy an assembled Panelolu2 that will work with my Solidoodle3.

http://albuyeh.com/GD.png

2 Reply by adrian (edited by adrian 2014-03-15 03:49:17)

  • adrian
  • Member
  • Offline
  • From: Canberra, Australia
  • Registered: 2013-01-15
  • Posts: 1,623

Re: WTB: Panelolu2 for Solidoodle3

http://makemendel.com/mechanical-parts/ … rintrboard

You'll have to attach the headers to your Printrboard though... unless you buy a new printrboard

3 Reply by Abolfazl

  • Abolfazl
  • Member
  • Offline
  • Registered: 2013-09-29
  • Posts: 14

Re: WTB: Panelolu2 for Solidoodle3

Does that come with a case?

http://albuyeh.com/GD.png

4 Reply by Abolfazl

  • Abolfazl
  • Member
  • Offline
  • Registered: 2013-09-29
  • Posts: 14

Re: WTB: Panelolu2 for Solidoodle3

How do I find out if my S3 has the Printrboard or the other one (Sanguino?)

http://albuyeh.com/GD.png

5 Reply by adrian

  • adrian
  • Member
  • Offline
  • From: Canberra, Australia
  • Registered: 2013-01-15
  • Posts: 1,623

Re: WTB: Panelolu2 for Solidoodle3

if you read the listing, its +$10 for a case.

And if the stepper drivers are soldered on the board, and it says printrboard rev e on it, its a printrboard. http://reprap.org/wiki/printrboard

If the stepper drivers are on little daughter cards, then its a sanguinolou : http://reprap.org/wiki/Sanguinololu