1 Topic by TheOldMan

  • TheOldMan
  • Member
  • Offline
  • Registered: 2012-10-19
  • Posts: 21

Topic: Z okay, what about X and Y

Stock solidoodle software. No upgrades yet.

I changed over to a glass bed, and have the bed nicley leveled, and the Z axis stop set well.
But...On large prints, the extruder head goes off the sides of the platform (and extrudes into thin air).
Can I adjust the X and Y axis endstops? Does anyone know how?

Or is this a software problem?

2 Reply by Cwalster (edited by Cwalster 2012-11-16 04:21:46)

  • Cwalster
  • Member
  • Offline
  • Registered: 2012-09-12
  • Posts: 71

Re: Z okay, what about X and Y

Change it in software. In slicer, i have the center of my bed at X78 y75, because of the dump zone to the right. Im not sure where in skienforge the bed centering is, but somewhere in there, its there.