Topic: Slicer problem
When I try to slice the attached STL file, Slicer insists on putting a top across the thing, even when it is not there. The walls are 1 mm thick: I wonder if Slicer thinks they're too thin to print. Any thoughts?
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Solidoodle Discussion → Slicer problem
When I try to slice the attached STL file, Slicer insists on putting a top across the thing, even when it is not there. The walls are 1 mm thick: I wonder if Slicer thinks they're too thin to print. Any thoughts?
Maybe try running it through netfabb to see if that fixes it?
Someone on the Slic3r forum found a very small face that was oriented improperly. After I fixed that, all was well.
Someone on the Slic3r forum found a very small face that was oriented improperly. After I fixed that, all was well.
glad that you got it resolved.
SoliForum - 3D Printing Community → Solidoodle Discussion → Slicer problem
Powered by PunBB, supported by Informer Technologies, Inc.