Topic: Increasing print quality - Settings and/or calibration?
What I am starting to realize is that printing is almost an art where each print will have specific challenges that must be over come by changing settings in your slicer. This also seems to be the largest hurdle as I am having difficulty associating any specific setting with the problems I see in my prints.
Below is a yoda I printed from http://www.thingiverse.com/thing:10650 and I believe my first mistake was printing this Yoda instead of one of the "Lite" versions.
What settings or calibration should I change to clean up the gaps?
Are there any tutorials available that show pictures of bad prints and talk about what settings or calibration could help fix the specific issue?
I am using standard firmware and Skeinforge (I can't upgrade my firmware... waiting on a new ATMega chip).