1 Topic by dannydef

  • dannydef
  • Newbie
  • Offline
  • Registered: 2013-04-26
  • Posts: 1

Topic: Quantum Delta printer build

This is my first time post and would like to share my build with you guys. I'm good at building and production but I'm very new to the software and configuration of the Delta printer.  If I could get pointers to get started it would be appreciated. So far I've loaded the Arduino with Marlin ramps1.4. I also have interface up and running and communicating with the board. But that's it , I don't know what's next.

Post's attachments

Q 3D 44.jpg
Q 3D 44.jpg 864.27 kb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.

2 Reply by adrian

  • adrian
  • Member
  • Offline
  • From: Canberra, Australia
  • Registered: 2013-01-15
  • Posts: 1,623

Re: Quantum Delta printer build

Is there a Q 3D forum/set up guide? Its probably going to get you satisfaction a lot quicker.

Not saying you wont get assistance here, but the trials and tribulations you'll face with that setup are markedly different to a Solidoodle... Things like the discussions on Z-Wobble, Backlash and firmware tweaks are generally in respect to a Solidoodle and are for the most part are not transferable to the Q3D besides sharing the same theories.