1 Topic by Dan63 (edited by Dan63 2022-12-15 18:50:35)

  • Dan63
  • Newbie
  • Offline
  • Registered: 2022-12-15
  • Posts: 1

Topic: Emutag doesn't save PACK value, timout mode etc. hardware issue?

Hey guys, I'm new here. I have just bought an EmuTag (ntag213) and I'm struggling to set the PACK value as well as the sniffing mode 000000E0 at 0x2D. The Emutag allows me to write the values but as soon as I read the Tag again, the pack (0x2C) is restored to 00040000!

Same goes for the timeout mode enabled value of 000000E0. This one gets resetted to the first part of the UID in 0x2D. 0x2D to 0x2F aren't changeable as well.

I have also disabled the dynamic lock byte feature at 0x28. standard value was 000000BD and I have set it to 00000000 just to make sure.

Thanks for your help guys! It's driving me nuts already:-)

2 Reply by modfreakz

  • modfreakz
  • modfreakz
  • Member
  • Offline
  • Registered: 2017-12-02
  • Posts: 199

Re: Emutag doesn't save PACK value, timout mode etc. hardware issue?

Hi, reflash the firmware and you will be fine.

I send you link via PM.