1 Topic by soliforum.20.browseruk

  • soliforum.20.browseruk
  • Newbie
  • Offline
  • Registered: 2022-05-29
  • Posts: 4

Topic: Is this forum essentially dead?

I signed up here a week or so ago because threr appeared to be ongoing activity and many if not all Qs seemed to get responses.

However, I posted a couple of questions and got no responses.

And over the last few days I've watched the New posts screen and apart from my posts and a bunch of Arabic spam there have been no new posts responses.

Is this place dead?

Anyone recommend a better place to get help with SLA (mLCD) printing?

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: Is this forum essentially dead?

it is not dead dead, but unless you are into XYZ DaVinci printers, it is very slow

patience is a virtue

i myself have no experience with the SLA machines, so i tend to keep my nose out of those discussions

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1

3 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: Is this forum essentially dead?

Dead ?? er no !!
The onslaught of spam is a bit usual. There are several factors at play . Spring has sprung folks are outside enjoying the outdoors and the activities. 
also since solidoodle has been out of business for a couple years now as Heartless stated most traffic is focused on the xyz line.
And as previously stated I too tend to not get involved with sla questions.

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura