1 Topic by parentemv

  • parentemv
  • Member
  • Offline
  • Registered: 2014-12-05
  • Posts: 100

Topic: Davinci 1.0a 3rd party filament

can someone direct me on how to use 3rd party filament  without firmwares flash on davinci 1.0a

thank you!

2 Reply by Bert

  • Bert
  • Newbie
  • Offline
  • Registered: 2020-05-13
  • Posts: 2

Re: Davinci 1.0a 3rd party filament

You've been on this board for the better part of a decade, so you should know more than many.

Short answer:

1. Get an Android phone with NFC, install app (search modfreakz)
2. Get NTAG213 stickers from Amazon
3. Make tags
4. Use standard PLA filament

Long answer:
All the info is on this board. Spend a few hours reading it. It's awesome!

3 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: Davinci 1.0a 3rd party filament

looking in the right section of the forum is also useful - XYZ Printing would be the right place for this post.
pretty sure the question has been asked, and answered, many times

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1