Topic: Teflon blocks on carriages
Does anybody know why the 2 opposing Teflon blocks are used in place a plain bearing in two places on the rod end blocks on SD 2?
Is it to save on the cost of bearings or as an adjustment to compensate for binding?
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Solidoodle Discussion → Teflon blocks on carriages
Does anybody know why the 2 opposing Teflon blocks are used in place a plain bearing in two places on the rod end blocks on SD 2?
Is it to save on the cost of bearings or as an adjustment to compensate for binding?
Solidoodle was cheap. Check out the http://www.soliforum.com/forum/4/hacks-mods/ section
SoliForum - 3D Printing Community → Solidoodle Discussion → Teflon blocks on carriages
Powered by PunBB, supported by Informer Technologies, Inc.