1 Topic by tonyno

  • tonyno
  • Member
  • Offline
  • Registered: 2014-12-23
  • Posts: 135

Topic: 1.0A Finally Died

The other day, my machine stopped homing correctly. Turns out, one wire for the X end-stop sensor snapped after 1,062 hours of printing. Cut out the break, soldered ends back together and I'm up and running again.

2 Reply by rohman1

  • rohman1
  • Newbie
  • Offline
  • Registered: 2022-02-14
  • Posts: 1

Re: 1.0A Finally Died

Thanks for reporting this so we can learn from your experience.

I’m about to investigate what I think might be similar, that of a possible broken wire going to the extruded heater.