You are not logged in. Please login or register.
SoliForum - 3D Printing Community → 3D Printer Discussion → SainSmart Coreception 300
Does anyone in the forum own a SainSmart Coreception; https://www.sainsmart.com/collections/3 … d-printer?
It was $100 off and have been looking for a 24V CoreXY using linear rails for a while now and at $450 with it shipping out of Nevada is hard to pass up.
I just got delivered last week and I am preparing to assemble the unit. Curious if anyone had any tips or thoughts on the assembly and use before starting.
Thanks
My first impression is the frame apears a bit flimsy. you may want to add some additional 20/20 frame pieces. also the addition of gussets may help .
Kind of like the ft 5
Build it as is first then shake it see how much it flexes then go from there.
speed square will help insure everything is square.
I completely agree and have the small two (2) screw corner brackets for the upper assembly and the "L" brackets for the bottom of the printer to attach on the outside of the extrusion pieces.
Outside bottom:
https://www.amazon.com/gp/product/B07PP … &psc=1
Inside corners:
https://www.amazon.com/gp/product/B076D … &psc=1
Heated bed insulation:
https://www.amazon.com/gp/product/B07DW … &psc=1
If i were building that machine i would likely use the outside bottom corners and some of these
https://www.amazon.com/KOOTANS-Bracket- … B07PPDXD93
to attach about 6 more pieces of 2020
But I am not the builder here, you are . Any aditional support you ad is better than none.
SoliForum - 3D Printing Community → 3D Printer Discussion → SainSmart Coreception 300
Powered by PunBB, supported by Informer Technologies, Inc.
