1 Topic by dubbsd

  • dubbsd
  • dubbsd
  • Member
  • Offline
  • From: Northwest florida
  • Registered: 2012-09-30
  • Posts: 748

Topic: Wall thickness question

I am printing with a .8mm nozzle the max wall thickness of the part is 4mm will i get a good part if I print 1 wall line count and 100% infill.

Thanks
Dale

Ultimaker S3.

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: Wall thickness question

what does the part look like when sliced?

that will tell you more than anything else.. look at the sliced layers and see how they lay out

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1