1 Topic by Vixx

  • Vixx
  • Newbie
  • Offline
  • Registered: 2020-05-08
  • Posts: 8

Topic: Motor throwing objects off turntable

One of the numerous issues I've been having with my Atlas is that about a third to halfway through a scan the objects on the turntable get thrown off of it.  This seems to happen primarily with tall or thin objects.  Is there a setting I can adjust to help with this problem?

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Motor throwing objects off turntable

It should not turn fast enough to throw anything off. It should turn just a fraction, pause for the scan and repeat till done. If the start and stop is too fast you may have to look at the code and check acceleration settings.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

3 Reply by hairu526

  • hairu526
  • Member
  • Offline
  • Registered: 2014-01-28
  • Posts: 494

Re: Motor throwing objects off turntable

Vixx,

You should have received a high friction liner for the turntable to prevent objects from slowly moving as the table turns.

Uriah

4 Reply by Vixx

  • Vixx
  • Newbie
  • Offline
  • Registered: 2020-05-08
  • Posts: 8

Re: Motor throwing objects off turntable

hairu526 wrote:

Vixx,

You should have received a high friction liner for the turntable to prevent objects from slowly moving as the table turns.

Uriah

I did, but it also slips around, Perhaps I should score the PLA table so it has more surface area to grip the liner