1 Topic by apetrosky

  • apetrosky
  • Newbie
  • Offline
  • Registered: 2013-11-29
  • Posts: 3

Topic: Solidoodle 3 Motherboard to Hot End Wire

Does anyone know the name of the red wire assembly that runs from the motherboard to the hot end connector? I have one that shorted out and I need to replace it.

Post's attachments

20200421_175514.jpg
20200421_175514.jpg 1.36 mb, file has never been downloaded. 

20200421_180050.jpg
20200421_180050.jpg 1.18 mb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: Solidoodle 3 Motherboard to Hot End Wire

that would be for the heater cartridge and you are not going to get one made exactly like that because that was Solidoodle specific, and they no longer exist.

so, buy an appropriate heater cartridge, and either run the new wires to the motherboard, or make a new connection at the Extruder.

XT30 RC battery connectors make a real good option. They are perfectly sized, and are intended for high electrical currents. That does, however, mean that you will need to be able to make good solder connections

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1