1 Topic by TheJadeRabbit

  • TheJadeRabbit
  • Newbie
  • Offline
  • Registered: 2020-04-13
  • Posts: 2

Topic: Da Vinci Jr 1.0 shutting off at boot

Hi hopefully I can get some help here because this is driving me crazy. Whenever I try to print a file, the printer turns off after verifying the file and resets itself. The file was sliced in the XYZ Maker Suite for the DaVinci Jr 1.0 which I have. The file is fine because it prints on my other printer and this printer takes it fine. I also tried printing over usb, but that had the same problem. I tried a different sd card with no luck, so I formatted that one as Fat32, but it still didn't work. The connections I believe to all be fine, so I think it is an issue with the firmware. Although it is at 2.4.9, the newest, so I don't know what the problem is now. Thanks!

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: Da Vinci Jr 1.0 shutting off at boot

you would get a better response if you posted this in the "XYZ Printing" sections that are dedicated to that family of printers.

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1