1 Topic by dosveces

  • dosveces
  • Newbie
  • Offline
  • Registered: 2020-04-07
  • Posts: 2

Topic: Please, help me. My Da Vinci 1.0A is making this horrors

http://soliforum.com/i/?srH4YVh.jpg
http://soliforum.com/i/?5oDTagJ.jpg
http://soliforum.com/i/?tFKvUap.jpg
http://soliforum.com/i/?fO4df6B.jpg
http://soliforum.com/i/?FiEigtG.jpg
http://soliforum.com/i/?jlhf0wr.jpg

I was making some protection masks for doctors and nurses (those masks ran out in Spain)  . I'd print a lot of them and I hadn't any problems. But suddenly they started go wrong.

I've changed the nozzle by a new one. But it doesn't get better.

Can you help me ?

It's a problem with the electric feed of the resistor heater of the nozzle?

It's a problem with the gear of the x-axe?

It's a problem with the servomotor (engine) of the x-axe?

It's a problem with the stl file? The samples inside the printer goes right.

Please, help me.

2 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: Please, help me. My Da Vinci 1.0A is making this horrors

check your belts  & pulleys looks like something slipping

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

3 Reply by dosveces

  • dosveces
  • Newbie
  • Offline
  • Registered: 2020-04-07
  • Posts: 2

Re: Please, help me. My Da Vinci 1.0A is making this horrors

I think they're right.

V.

4 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: Please, help me. My Da Vinci 1.0A is making this horrors

you can not think you need to check

I was making some protection masks for doctors and nurses (those masks ran out in Spain)  . I'd print a lot of them and I hadn't any problems. But suddenly they started go wrong.

check mechanical first then electronic   I doubt it is a software issue if the thing printed fine then things went belly up.

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura