1 Topic by lt72884

  • lt72884
  • Member
  • Offline
  • Registered: 2018-05-01
  • Posts: 120

Topic: Nfc tags might not work anymore

Ok, so i just did the e3d conversion. Things are going well, but when i tried to print over usb with new version of xyzprint, it did something that i have never seen. It said that the current reels serial has allready previously been used. Please send a picture to tech support of the products serial number. I can still save to sd card, but not use usb. Anyone else have this issue? I have not converted over to ramps. Still using stock firmware.

2 Reply by jgc068

  • jgc068
  • Newbie
  • Offline
  • Registered: 2020-01-11
  • Posts: 8

Re: Nfc tags might not work anymore

XYZ have updated the security in their firmware to make 3rd party tags unusable. See previous posts on this forum regarding using Cura software to bypass the issue when printing thro the usb port.