1 Topic by dubbsd

  • dubbsd
  • dubbsd
  • Member
  • Offline
  • From: Northwest florida
  • Registered: 2012-09-30
  • Posts: 748

Topic: GLUING PETG question

I have been gluing a lot of PETG lately and superglue is expensive and a PITA. to work with.
I buy Epoxy by the quart I can control it by the amount of hardener I put in it. will it work with PETG and ABS.
or is their any something  else you would recommend.
Thanks
Dale.

Ultimaker S3.

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: GLUING PETG question

it should work, but I would test on some scrap pieces first.
I have used a 5min epoxy on ABS before and it worked fine

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1