1 Topic by Fabz

  • Fabz
  • Newbie
  • Offline
  • Registered: 2019-12-16
  • Posts: 1

Topic: Power supply unit

Hello, ive seem to missplaced the psu of the unit i bought and wanted to see if anyone could tell me the specs of the psu to the scanner so i can go get a new one. Much appriciated.

2 Reply by slimstar2

  • slimstar2
  • slimstar2
  • Member
  • Offline
  • From: North Providence Rhode Island
  • Registered: 2014-03-28
  • Posts: 144

Re: Power supply unit

5 Volts 2 or 2.5 Amps works well

SD3, RAMPS 1.4, Lawsy's carriages modified by me, 2 SSRs, E3D V6, 2 Power supplies, Independent monitoring of both power supplies (amps and volts) also extruder and bed temps, Blue Tooth connectivity, bearings in all axis & rotational points, Y axis direct drive.  Remotely controlled power box on / off . Gecko Tec build plate . Renamed FrankenDoodle