1 Topic by morgan1

  • morgan1
  • Newbie
  • Offline
  • Registered: 2019-11-16
  • Posts: 1

Topic: 3D printer is not working

I have both a 3D printer and a HP printer and I wanted to connect with with my PC. MY 3D printer was connected with my system earlier. Then I wanted to connect my hp printer with my router and at that time, it wanted a WPS pin. I found the WPS pin on hp printer after searching many websites and then I connected it. But after that, my 3D printer doesn't working anymore. What should I do now?

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: 3D printer is not working

the HP printer most likely has "stolen" the connection the 3d printer was using.
you will most likely have to reinstall the 3d printer & its associated driver

once you do get it connected again, I highly recommend going into your computers device manager and setting the COM port to a much higher number to prevent this from happening again.

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1