1 Topic by mongozen

  • mongozen
  • Newbie
  • Offline
  • Registered: 2019-10-31
  • Posts: 1

Topic: Prints only print rough on the right side of the printer

Printer: Monoprice Select v2
Filament: Overture White PLA
Printing Temp: 220º C

I just switched to this filament (cheap from Amazon) and it prints fine until it gets to the right side of the object (see attached pics).  I am at a loss for a setting to address this.  I am going to do a temperature test print as well as an overall quality check but I have not run into this before where a specific area of each print is being affected.

http://soliforum.com/i/?4K4qRMN.jpg
http://soliforum.com/i/?vXSgEwj.jpg

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: Prints only print rough on the right side of the printer

i would suggest that 220 is too hot... try 200
also make sure the spool is turning freely, not hanging up at all

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1

3 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Prints only print rough on the right side of the printer

Do you have a layer fan and does it blow from only one side?

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

4 Reply by Kronikabuse

  • Kronikabuse
  • Kronikabuse
  • Member
  • Offline
  • From: Wi
  • Registered: 2014-08-03
  • Posts: 709

Re: Prints only print rough on the right side of the printer

Is it bowden fed? When it gets to the rough side the tube could be making the filament hang up

Sd4 #9080 with a glass bed. E3d chimera duel extruder. Paste extruder , duet wifi.
Lawsy carriages. linear bearings. Y axis direct drive, Kinect scanner
SD4#8188 glass bed, lawsly carriages, E3d v6, octoprint http://www.ustream.tv/channel/hotrod96z28
Filastruder/filawinder, Custom Delta 300mm x 600mm