1 Topic by dubbsd

  • dubbsd
  • dubbsd
  • Member
  • Offline
  • From: Northwest florida
  • Registered: 2012-09-30
  • Posts: 748

Topic: Printer vibration

I am fixing to order an Ultimaker S5 it ways about 45 LBS. I am thinking about setting it on plywood mounted with drawer slides so I can pull it froward to work on it. do you thing the printer would vibrate to much not setting on a solid desk top.

Thanks Dale

Ultimaker S3.

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: Printer vibration

you would be better off putting it on a wheeled cart.

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1