1 Topic by diyengineer

  • diyengineer
  • Member
  • Offline
  • From: USA
  • Registered: 2013-10-18
  • Posts: 309

Topic: Cura extrusion width

.4 nozzle, and...

.1 layer height
.2
.3

What is everyone using for width of extrusion?

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: Cura extrusion width

extrusion width should typically be 120% of nozzle diameter. for a 0.4 nozzle that would be 0.48
Layer height has nothing to do with it.

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1