1 Topic by knucklbustr (edited by knucklbustr 2019-09-02 18:00:14)

  • knucklbustr
  • Member
  • Offline
  • Registered: 2014-10-15
  • Posts: 137

Topic: Davinci 1.0 No Bed and Nozzle Heat

Ran a manual bed leveling and no heat temp readings.
Extruder/nozzle is on.
It happened after vacuuming inside, while printer on. Possibly touched something w/ the metal end of vacuum hose.

Non-stock early DAV 1.0.

No power at nozzle and bed. No power at black nozzle cables on MB.
Top white connector 0v. Bottom black connector 3v.
3v, 5v, 12v leds are lit.

Ive read that J47 fuse, is a common problem when touching nozzle w/ metal.
Found no J47 on MB.

How to find this problem ?

Post's attachments

mb01.jpg 367.49 kb, file has never been downloaded. 

mb02.jpg
mb02.jpg 466.46 kb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.
DaV1.0  10/13
Repetier FW 0.92, Solidify3D

2 Reply by knucklbustr

  • knucklbustr
  • Member
  • Offline
  • Registered: 2014-10-15
  • Posts: 137

Re: Davinci 1.0 No Bed and Nozzle Heat

Update.

I can manually turn on the nozzle and bed using the display panel, repetier .092.

Still wont turn on using manual leveling and printing software.

DaV1.0  10/13
Repetier FW 0.92, Solidify3D

3 Reply by knucklbustr

  • knucklbustr
  • Member
  • Offline
  • Registered: 2014-10-15
  • Posts: 137

Re: Davinci 1.0 No Bed and Nozzle Heat

Reloaded firmware.
It works now.
So strange.

DaV1.0  10/13
Repetier FW 0.92, Solidify3D

4 Reply by knucklbustr

  • knucklbustr
  • Member
  • Offline
  • Registered: 2014-10-15
  • Posts: 137

Re: Davinci 1.0 No Bed and Nozzle Heat

Spoke to soon.
LCD panel control>Manual bed leveling will not heat up the extruder and bed.
If the manual controls, of the printing software, are used to heat up both, then the bed leveling will start when reached temps.

Back to printing.

DaV1.0  10/13
Repetier FW 0.92, Solidify3D