1 Topic by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Topic: Check your Z screws...

Azerate asked me to share this with everyone here, since he is kind of limited on internet access with the storm coming in..

He was going to check into some Z banding on one of his printers (his Spookidoodle) and discovered this..

http://soliforum.com/i/?zLw0yzA.jpg

yes, you are seeing that correctly, the Z screw is broken in two...

another view after pulling it out..

http://soliforum.com/i/?CUjMQY8.jpg

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1

2 Reply by diyengineer

  • diyengineer
  • Member
  • Offline
  • From: USA
  • Registered: 2013-10-18
  • Posts: 309

Re: Check your Z screws...

dang!