1 Topic by lt72884 (edited by lt72884 2019-08-26 02:52:11)

  • lt72884
  • Member
  • Offline
  • Registered: 2018-05-01
  • Posts: 120

Topic: discontinuous first layer prusa slicer

Ok, below are two images i took. both of the exact same file. One printed in Simplify 3d, while the other is printed with prusa slicer. Notice how the S3d has continuous lines for the first layer, from one end to the other. However, the prusa slicer, exact same settings for temp, speed, etc, the lines are very randomly discontinued. They stop in the middle, then startup again.

http://soliforum.com/i/?B2uSPFe.jpg
http://soliforum.com/i/?R71ty4t.jpg

Is this due to a setting in the prusa slicer? or is it a bug? the algorithm, settings, etc? thanks

In the software for prusa, the sliced image looks like it should, continuous lines..

2 Reply by lt72884

  • lt72884
  • Member
  • Offline
  • Registered: 2018-05-01
  • Posts: 120

Re: discontinuous first layer prusa slicer

bumping