Topic: prusa slicer creates seam that wont print
Ok, so i am trying to print this:
https://www.thingiverse.com/thing:35383
I am printing it vertical. In prusa slicer 2.0, when i try at any layer height, it creates these seams along the fuselage of the aircraft, on both sides. When it prints, the pieces are not connected, the print head just skips that half mm section. I have tried in S3d and its fine. But i want to get it to work in prusa slicer. thanks
FWIW: I always print in steps of 0.04mm. I have tried for this stl 0.2,0.24......0.36 and the seams still happen