1 Topic by tecto (edited by tecto 2019-04-27 13:49:28)

  • tecto
  • Newbie
  • Offline
  • Registered: 2019-04-27
  • Posts: 1

Topic: [1.0a] Adjusting bed and extruder temperatures during filament hack?

Hello.
On below video on 2:15 min is showed how to adjust bed and extruder temperatures during hacking of the filament for DaVinci 1.0a.
I had no opportunity to check that so this is why I want to ask, whether it is really possible to do that?
Does any of you was able to change these temperature during flashing the cartridge?
If yes does it change the temperatures for this hacked cartridge only or let say - globally?