Topic: printing out of area error?
Running an Ultimaker, using Cura III that came with it.
Most of my part runs work normally, and I get good prints.
Sometimes, I have made a new gcode file, and the parts print normally, can't see anything wrong with them even, but the printer is stopped with "printed out of area" error on the display.
If a file does this once, it does it every time I run it. If a file doesn't do this, it never does it.
The parts are nowhere near the limits of size of the area the machine can print.
is there some way to debug the gcode?
3D printer - Monoprice Maker Ultimate with mods-
microswiss hot end, Bondtech extruder, twin cooling fans & ducts, insulated heater block, enclosed with Lexan like the Wanhao D6 it is based on.