1 Topic by simonc

  • simonc
  • Newbie
  • Offline
  • Registered: 2018-11-25
  • Posts: 4

Topic: Da Vinci 1.0 Pro circuit board needed from filament drive assembly

Does anyone have this circuit board for sale new/old as long as its working.
It fits just above the filament drive unit and attaches with a 2" 3pin cable to the drive sensor.


http://soliforum.com/i/?dPYs6RS.jpg

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Da Vinci 1.0 Pro circuit board needed from filament drive assembly

It would probably be easier to source the connector and just replace it. Unless somebody is gutting and/or scrapping a printer you can't just get one of these boards. I would try to source the connector.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

3 Reply by simonc (edited by simonc 2018-11-29 11:45:37)

  • simonc
  • Newbie
  • Offline
  • Registered: 2018-11-25
  • Posts: 4

Re: Da Vinci 1.0 Pro circuit board needed from filament drive assembly

Looking at it it looks like Molex PICOBLADE 53048 which are readily available from RS Components along with a 50mm cable which I've just order for just over £5.

It's finding someone suitably qualified and equiped to do the repair without unwittingly trusting it to some hobbiest that advertises pcb repairs in his shed as it's a very minute connection on the board.

http://soliforum.com/i/?qwRsIqB.jpg

[Update] XYZ have agreed to replace the parts so either way I'll be back up and running in days or weeks.