You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Projects → Madox-01 Mech
I'm a fan of the OVA "Metal Skin Panic Madox 01", and with a 3d model so hard to come by I figured to whip up my own for fun.
Thank god for a good reference picture
It is more or less a rigged 3d model: apparently the default pose in the pic makes it back heavy.
Waiting to see how the print turns out -15cm tall @ 16 hours printing- before I upload the pose to thingiverse.
I am betting this is going to give you all kinds of problems and require major support. But good luck. You are far braver than I. I doubt even my SLA could pull that off without a lot of support.
I am betting this is going to give you all kinds of problems and require major support. But good luck. You are far braver than I. I doubt even my SLA could pull that off without a lot of support.
Just a little support:
Lol
Older versions of the default DaVinci program seem to work pretty well when it comes to slicing and supports, and since I make my own NTAG filament chips I'm a bit more adventurous with PLA.
Funnily enough, it wasn't a complete disaster at 0.3mm layer height:
Most of the odd bits are from XYZ getting confused about my bad 3d modeling. Still, came out in one piece (I snapped off a wing on purpose to get into the supports.
But I'm working on a more... friendly way of printing it:
Gotta re-do the right arm (the one with the gattling gun) because no matter what the sliced result is fubar. Gonna try a 0.1mm layer height with the bits.
Started printing out the bits @ 200% 0.3mm layer height.
Comes out around 9"/22mm height, making it about 1/9th scale. Planning to sand it down & paint.
Edit: Uploaded to thingiverse
https://www.thingiverse.com/thing:3078651
SoliForum - 3D Printing Community → Projects → Madox-01 Mech
Powered by PunBB, supported by Informer Technologies, Inc.
