Topic: ThreeDubber - Fixed Percent and Time Remaining
For a little while now, I have been using XYLenTech's ThreeDubber program to use Cura with my DaVinci Jr 1.0. I am also using kr15_uk's Cura profile for the DaVinci Jr in Cura.
I noticed a few things about using ThreeDubber that bothered me slightly:
1. The "percent complete" would always show 100%
2. The "time remaining" would always show 1 minute
3. There was no way to adjust the temperature (the printer ignores the absolute temps in the gcode for the temp on the chip)
4. If someone had the optional 0.30 mm nozzle, there was no way to tell the printer to use that
Now, I'm no programmer, but I have some familiarity with scripts and programs. I used XYLenTech's source code to fix these issues. Right now, it will take a gcode file from Cura 3.4.0 and make a 3w file with all the settings set to fix the issues listed above. If it can't read the settings needed from the file, it will allow you to change them manually. Nozzle diameter and Temp can always be set manually.
Like I said though, I'm no programmer. It likely wont work if you give it a file from another program. It doesn't have any exception handling, so it may just crash when you try to load files. But I figured, if it helps anyone else, it was worth posting it. If there is anything else you'd like to see it do, let me know. I'll try my best.
kr15_uk's Cura Profile: https://www.thingiverse.com/thing:1915076
The original ThreeDubber: http://www.soliforum.com/post/113862/#p113862