Topic: Help with Z axis binding(Think its a firmware issue)
Hi, I was hoping for some help. I am using a da vinci 1.1 plus converted to use marlin RC8 with a ramps 1.4 board. I have upgraded the extruder to a E3D V6 and just installed a Bltouch auto bed leveler(no clones).
I am having an issue with the Z axis binding when homing only, it goes up and down the entire length of the threaded rod without issue when not homing. Another weird bit is it only binds sometimes also If I manual spin the rod the z axis starts moving again.
My question is can a software issue cause this? When I get off tonight I am going to try messing with the steppers pot. Any chance that could help? Any other ideas?
Thanks