1 Topic by whttnbrg

  • whttnbrg
  • Member
  • Offline
  • From: South of New Orleans
  • Registered: 2017-06-09
  • Posts: 41

Topic: Hello from Louisiana

I am new to Solidoodle, but not 3d printing. I currently own a couple cubes, but ran across a soli3 on the local facebook marketplace. It was sold as is, "Not Working". I brought it home, and after a look over, it had a broken heater wire as well as a broken y axis drive gear. Both of these being easily repaired, I now have a working Soli 3.

Now that I have it setup and running, I am starting to love this little gem.

My Name is Doug, and I am from New Orleans La.

3D Systems Cube, Hacked for Bulk Filament
Monoprice Replicator built from kit
Solidoodle 3, E3D Lite6, Rumba Upgrade
FT-i3 Mega, Looking for Dual Extruder Mods

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,623

Re: Hello from Louisiana

Welcome to the forum.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

3 Reply by AZERATE

  • AZERATE
  • AZERATE
  • PRINTiT
  • Offline
  • From: Chicago
  • Registered: 2013-11-28
  • Posts: 2,077

Re: Hello from Louisiana

Welcome Doug!
Solidoodles, once dialed in, modified as needed, out perform some "prestigious" units of higher expense and of more common names. Any Solidoodle related questions you may have should be researched and asked here as we have a great community.

After all, this is where the founders for Printit met! wink

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!