Topic: Stall Protection Board Readings - Questions
Just finished putting the filastruder together. Im trying to fine tune the Stall Protection Board, and after following the instructions to turn the CV and CC the correct number of times after the zero mark, these are my readings. Im assuming the 0.25A reading is for Amps? If so I believe my reading is too low, as the directions referenced a "current limit of 1.4-1.6 amps". Is this true? I am quite new to all this so I would just like to double check my work before I start using it! Also, I am not sure which LED light to pay attention to? Thanks in advance!