Topic: Changing motor pinouts on AIO scanner?
hey guys, I don't normally post much on forums, but I couldn't quite find anyone that has really done this yet.
I have a project up on thingiverse to create a single nozzle / dual extruder from the AIO
http://www.thingiverse.com/thing:1894980
My snag so far is the board is populated for the scanner motor and not the Extruder 2. I'm still learning arduino and continue to get errors attempting to find and swap it.
Not asking for a handout but maybe pointed in the right direction?
I've looked in both pins.h and userpins.h. noticed where most are indicated but didn't see any specific to the table motor for the scanner.