1 Topic by HyruleJedi86

  • HyruleJedi86
  • Member
  • Offline
  • Registered: 2015-05-11
  • Posts: 113

Topic: What kind of adapter

I'm replacing the extruding nema 17 motor with something new and most likely external as mentioned in another dead thread but I cannot find what kind of plug goes into the motor. I'd like to unplug the factory plug from the factory motor and buy the female connector to solder in place on my new motor then just plug the factory wiring in. The problem is I cannot find this plug anywhere, the closes I have found is a JST 6 pin but it looks too big everytime I get the measurements online.

Can anyone provide a link to this adapter?

2 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: What kind of adapter

http://www.ebay.com/itm/700mm-Wire-For- … Sw0fhXjYfU

is this what you are looking for ?

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

3 Reply by HyruleJedi86 (edited by HyruleJedi86 2016-09-05 13:47:07)

  • HyruleJedi86
  • Member
  • Offline
  • Registered: 2015-05-11
  • Posts: 113

Re: What kind of adapter

That's the right plug type. The plug that is on the Davinci Jr going to the main board looks like the right plug in the picture. I need a female version of that plug to wire onto the new motor so I don't have to do any cutting of a factory wire just to rewire with a new connector.http://soliforum.com/i/?9Tfd2Pm.jpg