printer: da vinci 1.0 aio (j37 jumper)
newest software from git
installation like the readme from git
1. erasing the original firmware
2. installing 1.6.9 with Sam 1.6.8 (replace the 2 files with that from repetier)
3. open the repetier.ino
4. config set "4" for aio device and "1" because of j37 board version.
5. flashing usb native without errors
6. printer stucks. 2 black stripes.
Edit:
I've tried everything.... different versions of arduino , different usb cable and ports (com ports)...
always the same....
Sometimes an error message but he uploaded and validated also but then nothing happens.
error message:
In file included from sketch\Configuration.h:185:0,
from sketch\Repetier.h:200,
from sketch\Commands.cpp:22:
sketch\pins.h:1425:140: warning: narrowing conversion of '128' from 'int' to 'const int8_t {aka const signed char}' inside { } [-Wnarrowing]
HEATER_0_PIN, HEATER_1_PIN, HEATER_2_PIN,FAN_PIN, E0_PINS E1_PINS E2_PINS TEMP_0_PIN, TEMP_1_PIN, TEMP_2_PIN, SDSS }
^
sketch\Commands.cpp:24:41: note: in expansion of macro 'SENSITIVE_PINS'
const int8_t sensitive_pins[] PROGMEM = SENSITIVE_PINS; // Sensitive pin list for M42
^
Der Sketch verwendet 205.584 Bytes (39%) des Programmspeicherplatzes. Das Maximum sind 524.288 Bytes.
sometimes no error but no function too.... is it possible to brick this board?
EDIT:
Next try with clean installation of windows and arduino and now i cant compile it.
Error:
In file included from C:\Users\Reepa Laptop\AppData\Local\Arduino15\packages\arduino\hardware\sam\1.6.8\cores\arduino/Arduino.h:42:0,
from sketch\Repetier.ino.cpp:1:
C:\Users\Reepa Laptop\AppData\Local\Arduino15\packages\arduino\hardware\sam\1.6.8\system/libsam/chip.h:25:17: fatal error: sam.h: No such file or directory
#include "sam.h"
^
compilation terminated.
exit status 1
Fehler beim Kompilieren für das Board Arduino Due (Native USB Port).
i have copy the files from repetier to "C:\Users\Reepa Laptop\AppData\Local\" and "C:\Program Files (x86)\Arduino\hardware"
board brick?