Topic: How to make your own Support structures
Where do I find the specifics on this. How thin, layer heights, etc?
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → 3D Modelling/Scanning/Design → How to make your own Support structures
Where do I find the specifics on this. How thin, layer heights, etc?
experimentation?
Meshmixer will allow you to create supports that you can control placement of as well as size etc...
Thanks, I'll take a look. I've made supports in the past but had probs getting them to release cleanly. Cura doesn't always put them where/how I want them to go.
SoliForum - 3D Printing Community → 3D Modelling/Scanning/Design → How to make your own Support structures
Powered by PunBB, supported by Informer Technologies, Inc.