1 Topic by satman49 (edited by satman49 2013-02-24 04:31:06)

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Topic: still stumped

Even tho RH shows the object in the center of the bed, it's printing  in the upper right quadrant. If I move the object in RH to lower left quadrant it prints in the middle.Is there a setting somewhere to tell it to print in the center?FYI all prints are doing this so far.

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.

2 Reply by nickythegreek

  • nickythegreek
  • Member
  • Offline
  • Registered: 2012-11-18
  • Posts: 673

Re: still stumped

Check out this thread:
https://groups.google.com/d/topic/solid … discussion

3 Reply by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Re: still stumped

thanks I'll take look.

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.