1 Topic by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Topic: stumped

I am doing my second print and even tho RH shows the object in the center of the bed it's printing  in the upper right quadrant. If I move the object in RH to lower left quadrant it prints in the middle, any ideas?

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.

2 Reply by nickythegreek

  • nickythegreek
  • Member
  • Offline
  • Registered: 2012-11-18
  • Posts: 673

Re: stumped

are you using slic3r in RH?

3 Reply by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Re: stumped

yep

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.

4 Reply by ronsii

  • ronsii
  • Member
  • Offline
  • From: PNW
  • Registered: 2012-10-28
  • Posts: 1,723

Re: stumped

can you post the .stl? also did the first print act this way or is it specific to this file?