1 Topic by Rotisiv

  • Rotisiv
  • Member
  • Offline
  • Registered: 2016-02-06
  • Posts: 28

Topic: Hello everyone I'm new to 3d printing

Want to say hi! I'm new to 3d printing and joined the forum hoping that if I have a problem somebody may give me advice as to what I should do. I do plastic injection and have found not all plastics react the same.

2 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: Hello everyone I'm new to 3d printing

Welcome to the group. I think you will find us a helpful lot.

Maybe you can teach us a thing or two about plastics.
Tin

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

3 Reply by driggers

  • driggers
  • Member
  • Offline
  • Registered: 2012-10-07
  • Posts: 162

Re: Hello everyone I'm new to 3d printing

Welcome!  Do you have a printer?  If so, which one?  If not, which one do you want? big_smile

SD2 Sanguinololu 1.3a atmega1284p, wood platform, lawsy's carriages, braided fishing line, pallet wood overhead spool mount, carboard/magnet enclosure, glass bed, E3D v6, bed levelling knobs, extended z-stop, 25A DC-DC SSR for bed heater, everything fixed to the SD2 frame, marlin firmware with some adjustments and extra failsafes enabled.  I'll never give up on you, little printer that could(n't)!

4 Reply by Rotisiv

  • Rotisiv
  • Member
  • Offline
  • Registered: 2016-02-06
  • Posts: 28

Re: Hello everyone I'm new to 3d printing

I have the da Vinci 1.0A  with firmware version 2.0.1.

5 Reply by Kronikabuse

  • Kronikabuse
  • Kronikabuse
  • Member
  • Offline
  • From: Wi
  • Registered: 2014-08-03
  • Posts: 709

Re: Hello everyone I'm new to 3d printing

welcome to the board

Sd4 #9080 with a glass bed. E3d chimera duel extruder. Paste extruder , duet wifi.
Lawsy carriages. linear bearings. Y axis direct drive, Kinect scanner
SD4#8188 glass bed, lawsly carriages, E3d v6, octoprint http://www.ustream.tv/channel/hotrod96z28
Filastruder/filawinder, Custom Delta 300mm x 600mm

6 Reply by dgaimhigher

  • dgaimhigher
  • Newbie
  • Offline
  • Registered: 2015-12-28
  • Posts: 5

Re: Hello everyone I'm new to 3d printing

Welcome, any inquiry about 3d printer filament, pls advise.