1 Topic by dylantep991

  • dylantep991
  • Member
  • Offline
  • Registered: 2015-03-24
  • Posts: 21

Topic: Replacement power supply

I lost my power supply for my press. Does anyone know where I can get a replacement?

2 Reply by cptskippy

  • cptskippy
  • cptskippy
  • Member
  • Offline
  • From: USA
  • Registered: 2014-09-17
  • Posts: 86

Re: Replacement power supply

I'd be interested in a replacement too.  I just tried to use my Press after an extended hiatus, it heated up and as soon as it reached temp and started the Z-Axis for homing it died.

I'm considering junking this piece of crap.

3 Reply by driggers

  • driggers
  • Member
  • Offline
  • Registered: 2012-10-07
  • Posts: 162

Re: Replacement power supply

dylantep991 wrote:

I lost my power supply for my press. Does anyone know where I can get a replacement?

MacGyverX says "The stock PSU is 24V @ 7.5A which is 180W" (he seems to be the local expert, as I don't have a Press.

Buy any 24v switching power supply, like this:

http://ooznest.co.uk/24V-360W-Power-Sup … oCtUDw_wcB

or these?
http://www.ebay.co.uk/bhp/24v-power-supply

And then hack it into the board (possibly by drilling a hole in the body of the press?)

SD2 Sanguinololu 1.3a atmega1284p, wood platform, lawsy's carriages, braided fishing line, pallet wood overhead spool mount, carboard/magnet enclosure, glass bed, E3D v6, bed levelling knobs, extended z-stop, 25A DC-DC SSR for bed heater, everything fixed to the SD2 frame, marlin firmware with some adjustments and extra failsafes enabled.  I'll never give up on you, little printer that could(n't)!