1 Topic by hansen644

  • hansen644
  • Member
  • Offline
  • Registered: 2014-09-10
  • Posts: 291

Topic: How to make a dual extruder setup?

Hi would like to know how would I go about make a dual extruder setup? I have a smartone 200 right now and would maybe convert that to one or just start from scratch.  Either way not real sure what all hardware I will need?

2 Reply by Kronikabuse

  • Kronikabuse
  • Kronikabuse
  • Member
  • Offline
  • From: Wi
  • Registered: 2014-08-03
  • Posts: 709

Re: How to make a dual extruder setup?

I went with a e3d chimera and a Ramps board on my solidoodle 4

Sd4 #9080 with a glass bed. E3d chimera duel extruder. Paste extruder , duet wifi.
Lawsy carriages. linear bearings. Y axis direct drive, Kinect scanner
SD4#8188 glass bed, lawsly carriages, E3d v6, octoprint http://www.ustream.tv/channel/hotrod96z28
Filastruder/filawinder, Custom Delta 300mm x 600mm

3 Reply by hansen644

  • hansen644
  • Member
  • Offline
  • Registered: 2014-09-10
  • Posts: 291

Re: How to make a dual extruder setup?

Hi I have a ramps 1.4  what other hardware would I need beside a extruder