1 Topic by mikeroc (edited by mikeroc 2016-01-10 06:00:27)

  • mikeroc
  • Newbie
  • Offline
  • Registered: 2016-01-02
  • Posts: 2

Topic: Square corners

My Davinci won't print sharp corners.  One of the 4 corners on a cube is pretty good, 2 are not very good and one is down right terrible.  The front right corner (as you look at the printer, front is closest to the user) is the best and the front left is the .  I assume this is a belt tension thing but I can't figure it out to save myself. 

I'm running Repetier FW, just loaded it tonight and these are the first prints, but I don't think Repetier is the cause.

Any advice would be GREATLY appreciated.

2 Reply by mikeroc

  • mikeroc
  • Newbie
  • Offline
  • Registered: 2016-01-02
  • Posts: 2

Re: Square corners

Just realized that the worst corner is the start stop point on the path.  Hopefully that gives somebody a clue to help me fix it....