1 Topic by Ham3D

  • Ham3D
  • Newbie
  • Offline
  • Registered: 2015-11-28
  • Posts: 5

Topic: SoliPrint 1.3.0 Crashes during z-axis calibration

The printer heats up then starts the calibration then after it finishes printing it homes then SoliPrint crashes. 

OS: Windows 7 64bit

2 Reply by seven2099

  • seven2099
  • Member
  • Offline
  • Registered: 2015-03-03
  • Posts: 101

Re: SoliPrint 1.3.0 Crashes during z-axis calibration

use some other software. Soliprint is garbage

3 Reply by cptskippy

  • cptskippy
  • cptskippy
  • Member
  • Offline
  • From: USA
  • Registered: 2014-09-17
  • Posts: 86

Re: SoliPrint 1.3.0 Crashes during z-axis calibration

seven2099 wrote:

use some other software. Soliprint is garbage

That's not terribly helpful.  How do you set the z-axis offset in GCode?

4 Reply by seven2099

  • seven2099
  • Member
  • Offline
  • Registered: 2015-03-03
  • Posts: 101

Re: SoliPrint 1.3.0 Crashes during z-axis calibration

Not trying to be mean, but given that Solidoodle has potentially gone kaput, it looks like their software will no longer be supported.

Honestly, use Repetier Server. Much easier, better than Soliprint. This will just require for you to use a slicer like cura.

In any case, if you're interested I can share how to set it up