1 Topic by zburhop

  • zburhop
  • Member
  • Offline
  • Registered: 2014-03-17
  • Posts: 101

Topic: Firmware update error.

Following these instructions...
http://support.solidoodle.com/hc/en-us/ … structions
 

I get this...... A couple others on the facebook page are getting this too but due to solidoodle apparently going out of business there have been no answers.



Connect USB to board
'hid_bootloader_cli' is not recognized as an internal or external command,
operable program or batch file.
okay to disconnect
Press any key to continue . . .



Thanks for your help.

2 Reply by zburhop

  • zburhop
  • Member
  • Offline
  • Registered: 2014-03-17
  • Posts: 101

Re: Firmware update error.

So I think I may have found the issue.  My printer was replacement for a defective unit I recently got from solidoodle.  I bet the new software is already on board.  I think this because the ath the head takes at the beginning of a print appears to be different then before.

3 Reply by daphur

  • daphur
  • Member
  • Offline
  • Registered: 2015-02-01
  • Posts: 52

Re: Firmware update error.

I'm having the same error, but I don't know is the new software is on my board.