1 Topic by proctor_richard

  • proctor_richard
  • Member
  • Offline
  • Registered: 2013-09-08
  • Posts: 157

Topic: infill problems

just recieved my RMA'd printer and i am getting the following problem.

the infill just does not adhere. on the first layer there seems to be big gaps between the tracks and it curls up and does not adhere to the layer below.

the perimeters seems to build ok.

any ideas?

Post's attachments

IMG_20150814_165315306[1].jpg 831.04 kb, file has never been downloaded. 

IMG_20150831_212958859[1].jpg
IMG_20150831_212958859[1].jpg 1.25 mb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.
SD2 - mirror bed - e3d v6 - extruder cooling fan - no enclosure.

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: infill problems

Have you properly calibrated the unit. The factory usually will not and if they did the shipping would change it.

You need to confirm your steps per mm on the extruder are correct then properly adjust your flowrate.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

3 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,623

Re: infill problems

I am guessing you are using Slic3r version 1.1.7? Switch back to version 1.0.0RC3

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website