1 Topic by machinistjoe (edited by machinistjoe 2013-01-26 18:36:26)

  • machinistjoe
  • Member
  • Offline
  • Registered: 2013-01-26
  • Posts: 64

Topic: Quick question about Slic3r error

Hi all. I have been getting this weird error when I try to use repetier with slic3r. I have uninstalled and re-installed, but I think something isn't getting deleted all the way. Any help would be much appreciated.

Thanks!

Post's attachments

Repetier error page.jpg 339.38 kb, 3 downloads since 2013-01-26 

You don't have the permssions to download the attachments of this post.

2 Reply by Wavesurf

  • Wavesurf
  • Member
  • Offline
  • Registered: 2013-01-16
  • Posts: 37

Re: Quick question about Slic3r error

In the Repetier "Printer Settings", Your "Post Slice Filter" is set to "Run Filter after every Slice". 

yourFilter #in #out  should be "perl C:\perls\add_M117_layer_info.pl #out" if you are trying to use the M117 layer x of x insertion perl script.  Where the c:\ is your path to the .pl file.

If you are not trying to do this or anything to the gcode after slicing, then uncheck the "Run Filter after every Slice" box.

If this is confusing, just uncheck the box to eliminate the error you described.

3 Reply by machinistjoe

  • machinistjoe
  • Member
  • Offline
  • Registered: 2013-01-26
  • Posts: 64

Re: Quick question about Slic3r error

Thanks wavesurf! All is well again.