Here are more informations in images about what happen :
Boot sequence:
My settings :
Object scanned :
Test image :
And errors message : as you can see, just after the first scan it announced about 10 hours remaining in 1.9M
Switching threshold to 5
Monitoring :
I switch to 5M still mode and change the threshold to 3 because the test picture seems better : all goes wright scanning speed as usual in this mode.
For completeness I made the test including cutting the mouse stand in settings page : doesn't change anything.
@ engineerd3d : 3 hours seems a lot for me, with 1.4 version I get a full scan in 5M still mode of the mouse you can see above in about 1H30. I guess it will depend on the object size.
For me, slow down means that the scan will take about 10 hours in 1.9M thus it takes about 20mn in 1.4 version for the same object/light/hardware and so on.
I guess 1.4 version given me high performance bad habits...
Freelss 1.7
Raspberry Pi 2
Piclop personnal design (check Website)
Direct RJ45 connection